Assemble the Stairs

JM4600 or DH77K Stairs... Stairs01L.png

Each set has two Bottom Blocks and one Top Block Stairs01L.png

The Top Block Stairs02L.png

The set goes together like this Stairs03L.png

Stretch tape sticky-side-up on the table Stairs04L.png

Glue on the bottom edge of the Top Block Stairs05L.png

Stick it to the tape, centered and square Stairs06L.png

Glue on a Bottom Block Stairs07L.png

Slip the top edge against the glue on the Top Block Stairs08L.png

Squeeze together then press down Stairs09L.png

The other Bottom Block - slip the top edge against the glue Stairs10L.png

Squeeze and press down Stairs11L.png

The tape is pulling it tight Stairs12L.png

Weight, then release the tape from the table so it can pull on the stairs Stairs13L.png

The Stringer will get attached behind the stairs, after installation IMG_2734L.JPG