Attic E-Slot

Cutting a slot for tapewire into the attic of a DH77K ../../RGT_Website_assets/ajax-loader.gif

01. This is the angle AtticE-Slot/01D.png

02. A piece of stripwood - this one is 3/4 wide AtticE-Slot/02D.png

03. Tracing the angle onto the stripwood AtticE-Slot/03D.png

04. AtticE-Slot/04D.png

05. cut to the tracing AtticE-Slot/05D.png

06. The layout stick is 5 1/2" long AtticE-Slot/06D.png

07. The angle guide taped in place AtticE-Slot/07D.png

08. The Oscillating Multitool following the angle exactly AtticE-Slot/08D.png

09. Hold the exact angle as you cut the slot AtticE-Slot/09D.png

10. The slot showing in the attic AtticE-Slot/10D.png

11. Clean up the rough edges AtticE-Slot/11D.png

12. You may have to run the Oscillating Multitool thru the slot again too AtticE-Slot/12D.png

13. Test the slot with tapewire AtticE-Slot/13D.png